Miracle Shield

Miracle Shield (MS)  is a specially modified water-based urethane acrylic coating that is non-hazardous with low VOC content.. This unique formulation provides a hard and durable clear gloss finish that also seals the surface and provides easy removal of graffiti by removing the coating itself (chemically or with pressure cleaning). It can be applied on all poured concrete, masonry, stucco, drywall, brick, metal and wood surfaces. Miracle Shield (MS) is ENVIRONMENTALLY SAFE !  It is non-toxic to humans, animals and vegetation.

TYPICAL USES: For industrial, commercial and residential use on surfaces of metal, masonry, wood, poured concrete, stucco, brick, block, stone, drywall, tile, grout, Adobe, wood siding, masonite, split face block, EFIS, previously painted surfaces, chalked or alkaline surfaces.

PHYSICAL PROPERTIES:
* Physical State: Color Milky - Dries Clear
* Gloss: Slight Sheen
* Solids: By Volume: 34.53% By Weight: 35.16%
* Coating VOC: 0.40 Lb/Gal (48 Grams/Liter)
* Flash Point: Non Flammable
* Theoretical Coverage: 200-300 sq.ft./gal depending on porosity of substrate (2 coats required)

APPLICATION :
MS is supplied ready to use. DO NOT THIN. Mix thoroughly prior to use. Easily applied with a quality brush, roller, airless spray and low pressure hand pump sprayer. Always apply material to test panel prior to general application.
Non-Porous Vertical Surfaces: Start first coat application at the top and spread a thin even coat, avoid over brushing. Apply second coat when the first coat is dry.
Porous Vertical Surfaces: Start first coat application at the top of the wall. Apply flood coat with a 6"-8" rundown and back-roll material into surface voids. Apply second coat when the first coat is dry.
Vertical Concrete Surfaces: Surfaces shall be clean and free of form oils and release agents.
Start first coat application at the top of the wall. Apply saturation coat and back-roll materials.
Apply second coat when the first coat is dry.
Horizontal Concrete Surfaces: Apply 2 saturation coats to damp concrete to assist the curing and hardening process. Apply 1 saturation coat to existing horizontal concrete surfaces to dust proof surfaces. Remove excess standing or ponding materials with a clean roller.
Brick: Apply 1 saturation coat with run-down and back-roll material. Apply second saturation coat when the first coat is dry. Caution: New brick surfaces should be allowed to weather for 12 months prior to application of material.
Stucco/Plaster: May be applied to stucco or plaster during the curing process or when fully cured. Apply 1 saturation coat and back-roll materials. Apply second saturation coat when the first coat is dry.
Chalked Surfaces: Apply 1 coat to chalked surfaces. Allow material to dry and check surface for chalking. Apply a second coat to surfaces as needed to control remaining surface chalk.
Wood: Surfaces shall be clean and bare. Pre-treat knots with a small amount of material. Apply a minimum of 2 saturation coats to wood surfaces. Apply second coat when the first coat is dry.

Coverage: Covers approximately 200-300 square feet per gallon depending on type of application and porosity of the surface to be treated.

Dry Time: Dries to the touch in 30 min at 75*F, may be re-coated in 3 - 4 hours depending on conditions. Clean up any spills, painting tools and equipment with warm soapy water.